Piezoelectric Amplifiers

The input signal is simple. Create a signal at the frequency for which the piezo device was designed to function. This can be done with a frequency generator, waveform generator, oscillator, or even a computer with a USB adapter. Once you have a signal, it must be amplified to a power level adequate for driving the piezo device.

In a typical power amplifier, your signal input is directly and fully amplified (all 360 degrees of the input cycle) and delivered as a higher power output with good signal quality and little distortion.

Impedance matching circuits may or may not be necessary, depending on the frequency of the device you are driving. Low frequency piezo devices (DC to 100kHz) are often used in non-resonant applications. Additionally, power amplifiers in these ranges are typically not load dependent and are designed for impedance mis-match. The impedance of the piezo device (load) in this case does not dramatically affect the amplifiers performance.

Driving high frequency piezo devices (100 kHz – 20 MHz), on the other hand, requires precise matching of the device impedance to the amplifier output. This can be achieved to an acceptable degree of accuracy using an adjustable impedance matching device or by designing a custom matching circuit.

APC is proud to offer a line of SVR amplifiers for powering actuator devices (DC-1 kHz), RF amplifiers for higher frequency devices (20 kHz – 12MHz @ 100W) and impedance matching boxes to take the mystery out of powering piezo devices. Custom power amplifiers are available through APC by request. APC is currently offering like new-used stock of several High Power LE Amplifier Systems but stock is limited so order soon!!!